Optical drive, Removing the optical drive, Replacing the optical drive – Dell Inspiron 14 (1440, Mid 2009) User Manual
Page 33
Back to Contents Page
Optical Drive
Dell™ Inspiron™ 1440 Service Manual
Removing the Optical Drive
1.
Follow the procedures in
Before You Begin
.
2.
Remove the battery (see
Removing the Battery
).
3.
Remove the screw that secures the optical drive to the computer base.
4.
Using a plastic scribe, push the notch to remove the optical drive from the optical drive bay.
5.
Slide the optical drive out of the optical drive bay.
Replacing the Optical Drive
1.
Slide the optical drive into the optical drive bay until it is fully seated.
2.
Replace the screw that secures the optical drive to the computer base.
3.
Replace the battery (see
Replacing the Battery
).
Back to Contents Page
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as the back panel) on the computer.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To help prevent damage to the system board, remove the main battery (see
Removing the Battery
) before working inside the
computer.
1
optical drive
2
screw
3
notch
4
plastic scribe