Camera (optional), Removing the camera, Replacing the camera – Dell Inspiron 14 (1440, Mid 2009) User Manual
Page 9
Back to Contents Page
Camera (Optional)
Dell™ Inspiron™ 1440 Service Manual
Removing the Camera
1.
Follow the procedures in
Before You Begin
.
2.
Remove the display assembly (see
Removing the Display Assembly
).
3.
Remove the display bezel (see
Removing the Display Bezel
).
4.
Disconnect the camera cable from the connector on the camera module.
5.
Release the camera module from the latches on the display cover.
6.
Remove the camera module.
Replacing the Camera
1.
Secure the camera module using the latches on the display cover.
2.
Connect the camera cable to the connector on the camera module.
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on the back of the computer).
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To help prevent damage to the system board, remove the main battery (see
Removing the Battery
) before working inside the
computer.
1
latches (2)
2
camera cable connector
3
camera module