Dell Alienware 13 (Late 2014) - Manual (Page 55)

Replacing the Status-Light
Board
WARNING: Before working inside your computer, read the
safety information that shipped with your computer and
follow the steps in Before Working Inside Your Computer .
After working inside your computer, follow the instructions
in After Working Inside Your Computer . For more safety best
practices, see the Regulatory Compliance home page at
dell.com/regulatory_compliance.
Procedure
1 Slide the status-light board cable into the status-light board connector
and press down the latch to secure the cable.
2 Align the screw hole on the status-light board with the screw hole on the
palm-rest assembly.
3 Replace the screw that secures the status-light board to the palm-rest
assembly.
Post-requisites
1 Follow the procedure from step 3 to step 4 in “Replacing the keyboard ”.
2 Follow the procedure from step 5 to step 9 in “Replacing the palm rest ”.
3 Follow the procedure from step 3 to step 7 in “Replacing the solid-state
drive ” .
4 Replace the base panel .
55