Replacing the display assembly, Procedure – Dell Alienware 13 (Late 2014) User Manual
Page 61
Replacing the Display
Assembly
WARNING: Before working inside your computer, read the
safety information that shipped with your computer and
Before Working Inside Your Computer
After working inside your computer, follow the instructions
in
After Working Inside Your Computer
. For more safety best
practices, see the Regulatory Compliance home page at
dell.com/regulatory_compliance.
Procedure
1
Align the screw holes on the display hinges with the screw holes on the
computer base.
2 Replace the screws that secure the display hinges to the computer base.
3 Route the logo-board cable through the routing guides on the display
hinge and connect the logo-board cable to the system board.
4 Route the display cable through the routing guides on the display hinge.
5 Slide the display cable into the connector on the system board and press
down the latch to secure the cable.
6 Route the antenna cables through the routing guides on the display
hinges.
7 Adhere the adhesive tapes that secure the antenna cables to the system
board.
8 Close the display and turn the computer over.
9 Connect the antenna cables to the wireless card.
The following table provides the antenna-cable color scheme for the
wireless card supported by your computer.
Connectors on the wireless card
Antenna-cable color
Main (white triangle)
White
Auxiliary (black triangle)
Black
10 Replace the screw that secures the wireless-card bracket to the wireless
card.
11 Adhere the adhesive tape to the wireless card.
61