Replacing the graphics card heat sink – Dell Alienware M15x (Early 2011) User Manual
Page 66
066
066
/
CHAPTER 15: GRAPHICS CARD HEAT SINK
Replacing the Graphics Card Heat Sink
Follow the instructions in “Before You Begin” on page
1.
6.
Place the graphics card heat sink in the computer base.
2.
Align the four captive screws on the graphics card heat sink with the screw
3.
holes on the graphics card and tighten the screws in sequential order
(indicated on the graphics card heat sink).
Replace the graphics card fan (see “Replacing the Graphics Card Fan” on
4.
Replace the left air-vent (see “Replacing the Air Vents” on page
5.
Replace the center control cover (see “Replacing the Center Control Cover”
6.
on page 31).
Replace the memory module(s) (see “Replacing the Memory Module(s)” on
7.
Replace the hard drive (see “Replacing the Hard Drive” on page
8.
18).
Replace the compartment door (see “Replacing the Compartment Door” on
9.
page 14).
Replace the battery pack (see “Replacing the Battery Pack” on page
10.
CAUTION: Before turning on the computer, replace all screws and
ensure that no stray screws remain inside the computer. Failure to do
so may result in damage to the computer.