Dell 928 All In One Inkjet Printer - Manual (Page 67)

303
Memory Error. Call Dell. Unable to initialise memory. Call the Dell Support Center.
305
Memory Error. Call Dell. Corrupted ROM. Call the Dell Support Center.
306
Paper feed Error. Call
Dell. Failure occurred when initialising DC paper
feed system.
Call the Dell Support Center.
120A
Printer Error. Restart
Printer. Microprocessor encountered an abort or
undefined instruction.
Switch the printer off and on again.
120B
Memory Error. Restart
Printer.
Attempt to access invalid address space. Switch the printer off and on again.
120C Memory Error. Restart
Printer.
Error detected reading or writing NVRAM. Switch the printer off and on again.
120D
Memory Error. Restart
Printer.
Stack over or under flow, code variable used
in switch / case logic out of acceptable
range in hardware control code.
Switch the printer off and on again.
1209
Flash memory
programming error. An attempt made at programming the Flash
memory has caused an error.
Switch the printer off and then on again.
Try to reprogram the Flash memory with
different firmware versions. Contact Dell
technical support.
1210
Invalid print mode
selected. Change print
mode.
Invalid print mode selected in print command
e.g. kind of error to look for.
Switch the printer off and on again.
1211 USB Error detected.
Restart Printer. Error in USB hardware detected, or invalid
result occurred in USB mode.
Switch the printer off and on again.
1212
Watchdog error. Restart
Printer. Indicates printer system reset by Watchdog
timer - Subsystem stall failure.
Switch the printer off and on again.
1213
Memory error. Restart
Printer. Attempt to load from, or store in, an invalid
address.
Switch the printer off and on again.
1214
Printer Error. Restart
Printer.
Indicates that the processor was in an
incorrect mode to perform the requested
operation.
Switch the printer off and on again.
1215
Printer Error. Restart
Printer. Problem doing maths, such as divide by
zero.
Switch the printer off and on again.
1218 Printer Error. Restart
Printer. Invalid parameters have been passed to
ReadFLASHPage.
Switch the printer off and on again.
1219
Printer Error. Restart
Printer.
Microprocessor encountered a bad signal
(other than an abort, illegal instruction or
arithmetic exception).
Switch the printer off and on again.
121A
Printer Error. Restart
Printer.
Error detected that a while loop, or similar,
timed out before the event it was waiting for
finished.
Switch the printer off and on again.
121B
Printer Error. Restart
Printer. Indicates that the Control Section of NVRAM
is corrupted.
Switch the printer off and on again.
2200
Printer Error. Restart
Printer.
The scan carrier has stalled. Switch the printer off and on again.
41B7
Undetected Bluetooth
device.
The Bluetooth device has not been detected.
Use a compatible Bluetooth device. See
"Printing from a Bluetooth-Enabled
Device".