Cisco IP/TV 3400 Series User Manual

Page 117

Advertising
background image

C-5

Cisco IP/TV 3400 Series Servers User Guide

OL-4467-01

Appendix C Instructions for Recovering IP/TV Servers

Recovering Cisco IP/TV 3426 and 3427 Servers

Step 6

Enter Yes to continue with the recovery process.

Note

If you need to back up files, enter No to abort the recovery process. Run
the recovery program after you have backed up your files.

The Attn. Read this before you continue window appears with a message to not
restart the system until the recovery procedure is complete.

Step 7

Enter Yes to begin the recovery of Cisco IP/TV 3427 Server.

The recovery program reimages the hard disk. The Recovery is Complete window
appears with a message that prompts you to remove the CD from the CD-ROM
drive before you restart the server.

Step 8

Remove the CD from the CD-ROM drive and press Enter to restart IP/TV Server.

IP/TV Server reboots. The recovery program installs Windows 2000, and converts
both SCSI hard disks in Cisco IP/TV 3427 Server from basic to dynamic using the
DiskPart utility.

IP/TV Server reboots again, and the Windows logon message box appears.

Step 9

Log in to IP/TV Server as administrator with the password default.

A DOS command window displays status messages as the recovery program
performs the following tasks:

Stops Cisco IP/TV Server and Cisco FTP Server services

Creates a striped volume for D:

Copies the directory C:\IPTVMedia to D:

Restarts Cisco IP/TV Server and Cisco FTP Server services

The DOS command window closes and the Windows desktop is displayed. Cisco
IP/TV 3427 Server is restored to the factory default configuration.

Step 10

Configure IP/TV Server.

For specific instructions, see

Chapter 4, “Setting IP/TV Server Configuration

Parameters.”

Advertising