Compaq MP1200 - Manual (Page 14)

Using the Projector
Compaq iPAQ Microportable Projector MP1200 User’s Guide 2–3
Connecting the Projector to a Desktop Computer
1. Connect one end of the projector signal cable into the
VGA-in connector on the side of the projector and the other
end to the DVI connector 1A or the VGA connector 1B on
the desktop computer and tighten the screws.
✎
Be sure the signal cable aligns with the connector. Do not force
the cable onto the connector or you may damage the signal cable
or the projector.
2. Connect one end of the power cord 2 into the side of the
projector, and the other end to an electrical outlet that is
easily accessible and close to the projector.
261799-001.book Page 3 Thursday, April 25, 2002 3:13 PM