Using auto power-on, Powering off the projector – Compaq MP1200 User Manual
Page 18
Using the Projector
Compaq iPAQ Microportable Projector MP1200 User’s Guide
2–7
Using Auto Power-On
The projector can be set to turn on automatically whenever a valid
signal is detected from an input source. This feature is disabled
for shipping. To enable it, use the Input Source Select menu item
in the On-Screen Display menu. Refer to Chapter 3, “Using the
On-Screen Display Menu,” for more information.
Powering Off the Projector
1. Press the
Power/Standby
button 1 to turn off the
projector lamp.
The message “Going to Standby” displays and the LED on
the
Power/Standby
button blinks amber.
Ä
CAUTION:
Wait until you see a steady amber LED (approximately
45 seconds) before turning the projector back on. Failure to follow this
caution can result in damage to the projector.
2. Once the
Power/Standby
LED has turned steady amber,
disconnect the power cord from the electrical outlet and the
projector 2.
261799-001.book Page 7 Thursday, April 25, 2002 3:13 PM