Thermcraft XST-3-0-36-3V - Manual (Page 61)

Operation Installation and Operation Handbook
2408 and 2404 Controller 2-13
Name Description
ProG Program edit list − Present only in setpoint programming controller.
For a fuller explanation of these parameters refer to Chapter 5
PrG.n Select program number (Only on 4, or 20, program versions)
Hb Holdback type for the program as a whole (if configured)( OFF, Lo, Hi, or bAnd)
Hb V Holdback value (in display units)
rmP.U Ramp units ( SEc, min, or Hour) [for both rmP.r and rmP.t type segments]
dwL.U Dwell units ( SEc, min, or Hour)
CYC.n Number of program cycles ( 1 to 999, or ‘cont’)
SEG.n Segment number
tYPE Segment type: ( End) (rmP.r=ramp rate) (rmP.t=ramp time) (dwel) (StEP) (cALL)
The following parameters depend on the tYPE selected, as shown below.
End rmP.r rmP.t dwEl StEP cALL
Hb Holdback type: OFF, Lo, Hi, or bAnd
tGt    Target setpoint for a ‘ rmP’ or ‘StEP’ segment
rAtE  Ramp rate for a ‘ rmP.r’ segment
dur   ‘ dwEl’ time / Time to target for a ‘rmP.t’ segment
PrG.n  cALLed ProGram number
cYc.n  No. of cycles of cALLed program
outn      Event output: OFF/on (not 8-segment programmer)
SYnc     Segment synchronisation: no/YES (not 8-seg progr)
End.t  End of prog − dwEl, RSEt, S OP