Tomei Powered ARMS M8280 - Manual (Page 17)

CAUTION
■ This manual only provides the information on the removal and re-installation of the turbo unit only.
For details on the disassembly and assembly of the other parts and components, please refer to the
official Toyota Service manual for your car.
■ This product has been designed for competition use only and is not to be used on any public roads.
■ This product will increase your engines power output so it is necessary to address and upgrade suit
your suspension and brakes to the increased power for added safety. Since the car is not designed
with this product in mind, please adjust the cars settings to suit the new product.
■ This product was designed specifically for the engine specified. If the attempt was made to use this
product(s) on another engine other than specified then you will risk of damaging the related parts in
this kit and/or the engine that it is used with.
■ This installation manual simply explains the removal and installation of the turbo unit as well as the air
pipe(s), heat shield and the coolant as well. Please read this manual carefully in advance to prepare all
the necessary tools required for the job.
■ This product is designed for competition use so it must be installed by an experienced qualified
professional with the correct equipment in an appropriate equipped workshop.
■ Protective equipment may be required for the installation process so please ensure there is the
appropriate safety and 1st aid equipment readily available for the installation.
■ It is best to work on the car when the engine is cold as it will prevent possible burns and or injuries
when the engine is hot.
■ When removing and re-fitting the parts please perform the job with care. Do not use excessive force
on the bolts and parts so as not to cause any damages to the parts and/or related parts.
■ Please tighten each bolt with a torque wrench. This will prevent any possible damages to the bolt
and also ensure that it won’t come undone.
■ Prior to testing the car please check for adequate levels of coolant and any signs of leakage. If there
are signs of lack of coolant, leaks and/or rapid rising of temperature stop the car immediately so as
not to risk engine damage.
■ Have a boost gauge fitted to your car (if not already) to monitor the turbo via the boost levels to
ensure that it is operating as normal
17
ensure that it is operating as normal.
REQUIRED TOOLS
The following tools are recommended for the installation process.
* General Maintenance Tools. * Torque Wrench * Service Manual
17