Vermont Casting Gas Grill - Manual (Page 12)

12
Assembly Step 3 - Assemble the Pillar to the Base
Tools Needed:
LOCATE THESE PARTS:
Base Assembly
USE HARDWARE PACK B :
M6x1x16mm
Bolt (10)
Flat
Washer (10)
Lock
Washer (10)
1.
2.
3.
4.
Set the Cylinder Support into the hole in the
Base as shown with the notch toward the
front.
Set the assembled Pillar panels onto the
Base Assembly as shown.
For each pre-threaded mounting hole,
insert a bolt, washer, and lock washer for
both the pillar and the cylinder support.
Firmly tighten the bolts.
Phillips head screwdriver
Cylinder
Support
Rear of Grill Assembly
Pillar assembled to Base:
NOTE: For easier assembly,
first loosely insert ALL of the
screws before tightening them.