Vermont Casting Gas Grill - Manual (Page 9)

10mm
Getting Started
Unpacking the Grill Parts
1. Please follow the steps in the order that
they are presented.
2. Assemble the grill where you plan to use
it.
3. You may want to place an old towel or
cloth at the assembly site to prevent nuts
and bolts from becoming lost.
4. For each step, loosely tighten all the
fasteners before tightening them completely.
5. Have a friend help. An assistant can
make the assembly easier by holding the
parts in place while you fasten the nuts and
bolts.
6. To be ready to barbecue immediately,
have the L.P. gas cylinder filled by an
authorized L.P. dealer or cylinder exchange
center.
1. Remove and set aside all inner boxes
and parts from the master carton.
2. Remove and set aside all wrapping
paper, zip ties, and additional protective
packaging from the parts.
3. Do not destroy carton or packing until
your grill is completely assembled and
operating to your satisfaction.
4. For ease and safety, lock the casters
during assembly.
Consumer:
Your grill is packaged with a merchandiser point-of-
purchase label. To remove the label, unscrew the
igniter button, remove and discard the label, then re-
attach the igniter button.
Retailer/Merchandiser:
Do Not remove the point-of-purchase label. Make
sure it is hanging properly for display in the store.
9
Assembly Instructions 2
Chapter
Stainless Series Gas Grill
10mm open-end wrench
phillips-head screwdriver
Tools needed to assemble grill:
·
·
(tools not included)