Vermont Casting Gas Grill - Manual (Page 26)

MATCH LIGHTING
Locating the Match Lighting Hole
Repeat steps 1 to 4 of “Igniter Lighting
Instructions.”
STEP 5. To match light: push down and turn the
burner control knob counterclockwise to the high
setting.
STEP 6. IMMEDIATELY strike a long wooden
match and position the burning match through
match lighting hole in the grill tub. Extend the
flame near a burner port in the burner. The burner
should light.
If a long-reach match or lighter is not accessible,
there is a match extension provided, attached
underneath the side burner table. Insert a match in
the holder end of the extension, strike the match,
and insert it through the match-lighting hole.
To light other burners, sequentially light one
adjacent burner at a time. DO NOT attempt to light
a burner that is not directly next to a lit burner
without using the igniter.
The match lighting holes are located beneath the
side tables in the sides of the grill tub.
2
6
Allow the grill to preheat with the grill lid closed
for five to ten minutes before cooking.
CAUTION: Do not touch any hot grill parts. The
outside of the grill bottom becomes very hot during
use. It may be necessary to use protective gloves.
STEP 1. Turn the burner-control knob(s) off. The
burner flame will go out.
STEP 2. Turn off the top L.P. cylinder valve by
turning the knob in a clockwise direction until it
stops.
IMPORTANT: Always have the gas shut off at the
L.P. cylinder valve when the grill is not in use. The
L.P. cylinder has a leak detection feature which will
restrict the amount of gas flow to the burner if the
tank shut-off valve has not been turned off prior to
the next use.
HOW TO SHUT OFF THE GRILL
Lighting Instructions
IMPORTANT: The match lighting holes are found
under the side tables, in the side of the grill tub.
When match lighting the grill, use the END gas
control knob on the side you are using (closest to
the match lighting hole).