Vermont Casting Gas Grill - Manual (Page 13)

13
Assembly Step 4 - Attach the Grill Head to the Pillar
Tools Needed:
LOCATE THESE PARTS:
Grill Head
Assembly
USE HARDWARE PACK C :
M6x1x16mm
Bolt (7)
Flat
Washer (7)
Lock
Washer (7)
1.
2.
3.
Set the Grill Head Assembly onto the top of the
assembled Pillar and Base as shown. Ensure
that the hose and regulator hanging from the
bottom of the Grill Head are on the inside of the
Pillar.
For each pre-threaded mounting hole, loosely
insert a bolt, washer, and lock washer. To make
assembly easier, start with the center mounting
hole of the front pillar panel and work around to
the sides.
After all of the fasteners have been loosely
placed, firmly tighten the bolts.
Phillips head screwdriver
Back Side of
the Assembly