Sony LBT-G2500 - Manual (Page 8)

To tune in a station with a weak
signal
[’ross TUNING MODE rt-poatodly in stop 2
until "MANUAL" appears, then press
TUNING +/- to tune in the station manually.
To change the preset number
Start over from step 1.
To change the AM tuning interval
(for models with the AM TUNING STEP
switch on the rear panel)
The AM tuning interval is factory-preset to
9 kHz (10 kHz in some areas). To change the
AM tuning interval, turn off the power and
set the AM TUNING STEP switch on the rear
panel to 10 kHz (or 9 kHz). Then turn the
power back on. When you change the
interval, all the preset stations will be erased.
Tip
The preset stations are retained for half a day even if
you unplug the power cord or if a power failure
occurs.
step 3: Presetting radio stations
(continued)
Connecting optional
AV components
To enhance your system, you can connect
optional components. Refer to the
instructions included with each componei
for details.
Connecting a turntable
Be sure to match the color of the plugs anc
the connectors. To listen to the sound frorr
the connected turntable, press PHONO.
To the audio output of the turntable
Note
Using the turntable at high volume may cause
distortion or howling. This is often caused by the
bass sound from the speakers. The bass sound mi.
be picked up by the needle of the turntable, and
produce the distortion or howling. To avoid this,
the following:
1 Keep some distance between the sp>eakers and
turntable.
2 Stop using the surround effect.
3 Install the speakers or the turntable on a firm a
stable surface.
4 Press DBFB repeatedly until "DBFB ^\\\\\ "
disappears from the display.
8