Changing an existing title [t, Erasing all titles on a disc (name erase function), Note that once erased, titles cannot be recovered – Sony MDS-S37 User Manual
Page 27: To cancel the name erase function, Q' you can erase all recorded tracks and titles, Undoing the last edit (undo function), To cancel the undo function
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Editing Recorded MDs
Changing an existing title [T]
1
Press NAME, then do the following:
To change
Make sure that the deck is
A track title
Playing, pausing the track whose title
is to be changed, or stopped after
locating the track whose title is to be
changed
A disc name
Stopped with no track number
appearing in the display
2
-4Ceep pressing CLEAR (or EDIT/NO on the deck)
until the current title is erased.
3
Enter the new title.
Do Steps 3 to 6 of "Labeling Recordings" on page
24, or Steps 2 to 4 of "Labeling tracks and MDs
with the remote" on page 26.
4
Press NAME.
Erasing all titles on a disc (Name Erase
Function)
Use this function to erase all titles on an MD
simultaneously.
Note that once erased, titles cannot be recovered.
1
Press EDIT/NO repeatetlly while the deck is
stopped until "All Erase ?" appears in the display.
2
Press EDlT/NO again.
"Name Erase ?" appears in the display.
3
Press YES.
All titles are erased.
To cancel the Name Erase Function
Press ■.
■Q' You can erase all recorded tracks and titles
See "Erasing all tracks on an MD" on page 21.
Undoing the Last Edit
(Undo Function)
You can use the Undo Function to cancel the last edit
and restore the contents of the MD to the condition
that existed before editing was done. Note, however,
that you cannot undo an edit if you do any of the
following after the edit:
• Press the # button on the front panel.
• Press the # button, the MUSIC SYNC button, or the
CD-SYNC STANDBY button on the remote.
• Update the TOC by turning off the power or ejecting
the MD.
• Disconnect the AC power cord.
EDIT/NO YES
appearing in the display, press EDIT/NO
repeatedly until "Undo ?" appears in the display.
"Undo ?" does not appear if no editing has been
done.
Press YES.
One of the following messages appears in the
display, depending on the type of editing to be
undone:
Editing done:
Message:
Erasing a single track
"Erase Undo ?"
Erasing all tracks on an MD
Dividing a track
"Divide Undo ?"
Combining tracks
"Combine Undo ?"
Moving a track
"Move Undo ?"
Labeling a track or an MD
Changing an existing title
"Name Undo ?"
Erasing all titles on an MD
3 Press YES again.
"Complete" appears for a few seconds and the
contents of the MD are restored to the condition
that existed before the edit.
To cancel the Undo Function
Press EDIT/NO or ■.
27