Labeling recordings (title function), To erase a character, To enter a space – Sony MDS-JE700 User Manual
Page 31: To cancel labeling, Note, Editing recorded mds
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Editing Recorded MDs
Labeling Recordings
(Title Function)
You can create titles for your recorded MDs and tracks.
Titles — which may consist of uppercase and
lowercase letters, numbers and symbols for a
maximum of about 1,700 characters per disc — appear
in the display during MD operation.
4
Turn AMS to select the character.
CHAR
EDIT/NO
IKM
AMS
OtXl
□
ac
© (S
"" o ^ o o
[) O O
0
o
Use the following procedure to label a track or an MD.
You can label a track while it is playing, pausing or
recording. If the track is playing or recording, be
sure to finish labeling before the track ends. If the
track ends before you've completed the labeling
procedure, the characters already entered are not
recorded and the track will remain unlabeled.
1
Press EDIT/NO repeatedly untH "Name in ?"
appears in the display, then do the following:
To label
Make jure that the deck is
A track
Playing, pausing, recording the track
to be labeled, or stopped after
locating the track to be labeled
An MD
Stopped with no track number
appearing in the display
2
Press YES.
A flashing cursor appears in the display.
4 S
« 7 e « w
11 12 13 14 IS
3
Press CHAR to select the character type as
follows:
To select
Press CHAR repeatedly until
Uppercase letters
"A" appears in the display
Lowercase letters
"a" appears in the display
Numbers
"0" appears in the display
ip}
The selected character flashes.
Letters, numbers, and symbols appear in
sequential order as you turn AMS.
You can use the following symbols in titles:
! " # $ % & ' ( ) ■ ' +
, -
. / : ; < = > ? © _ '
You can press CHAR to change the character type
at any time during Step 4 (see Step 3).
Press AMS to enter the selected character.
The cursor shifts rightward and waits for the
input of the next character.
4 5
6 7 S S 10
11 12 IS 14 1$
6
Repeat Steps 3 to 5 until you have entered the
entire title.
If you entered the wrong character
Press or ►► until the character to be corrected starts
flashing, and repeat Steps 3 to 5 to enter the correct
character.
To erase a character
Press or ►► until the character to be erased starts
flashing, then press CLEAR or EDIT/NO.
To enter a space
Press AMS or ►► while the cursor is flashing.
7
Press YES.
This completes the labeling procedure and the
title appears on the left side of the display.
To cancel labeling
Press ■.
Note
You cannot label a track or an MD while you are recording
over an existing track.
(Continued)
B 7 • I
11 12 13 1
1« 17 11
31