Ohm coaxial cable (round), Ohm twin-lead cable (flat), Connecting tv antenna/cable – Sony KV-27V55 User Manual
Page 12: Chapter 1: setting up
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Chapter 1: Setting Up
Connecting TV Antenna/Cable
Although you can use either an indoor or outdoor antenna with the TV, an outdoor antenna will provide you with better picture
quality. You can receive cable TV by connecting a C
2
d)le supplied by your local cable company.
Connecting VHP, UHF or VHF/UHF Combination Antenna , or CATV Cable
75-Ohm
coaxial cable (round)
1
Check your antenna cable type and prepare the end
of the cable using the F-type connector.
Attach an F-type connector (not supplied).
_ 7 mm (1/4 inch) 10 mm (3/8 inch) F-type connector
b
3
mm (1/8 inch)
C
d
300-ohm twin-lead cable (flat)
1
Check your antenna cable type and prepare the end of
the cable using the 300-ohm twin-lead cable.
Attach an antenna connector.
Loosen both
screws on the
connector with a
screwdriver.
Attach the cable
and tighten both
screws with a
screwdriver.
Plug the connector into the VHF/UHF terminal at the
rear of the TV.
Plug the connector into the VHF/UHF terminal at the
rear of the TV.
(Rear of TV)
VHF/UHF
(Rear
Of
TV)
^%Tc
VHFAJHF
IT
• Most combination antennas are equipped with a signal
splitter.
Remove the splitter and attach the appropriate connector.
For better picture quality, connect optional antenna cable so
that the 300-ohm twin-lead cable can be separated a
distance from the TV.
12
Chapter 1: Setting Up