Sony KV-27V55 User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Connecting Both VHP and UHF Antennas
Use an EAC-66
UN
mixer (not supplied).
1
Connect the cable to the mixer.
UHF
VHF
Prepare the VHF antenna end using the appropriate
connector (p. 12).
2
3
Attach the mixer to the VHF/UHF terminal.
When the U/V mixer is used.
Snow and noise may appear in the pictures when viewing cable TV channels over 37 (W-t-1).
Connecting a Dipole Antenna (KV-13V50 only)
Use the dipole antenna.
1
Attach the supplied antenna connector to the end of
the dipole antenna cable.
a
b
Loosen both screws
on the connector with
a screwdriver.
Attach the cable
and tighten both
screws with a
screwdriver.
Put the dipole antenna into the slot at the top of the
TV.
Plug the dipole antenna connector into the VHF/UHF
terminal at the rear of the TV.
Adjust the dipole antenna for better picture quality.
VHF/UHF
For better picture quality we would recommend you to connect an outdoor antenna.
Chapter 1: Setting up
13
a
S
I