Canon IXUS 990IS - Manual (Page 122)

122
You can cut out a portion of a recorded image and save it as a new image file.
Select [Trimming].
● Press the n button, select the 1 tab
and [Trimming], then press the m button.
Select an image.
● Press the qr buttons or turn the  dial,
select the image and press the m button.
Adjust the trimming area.
A frame will appear around the portion of
the image to be trimmed.
The original image will display in the upper
left and the trimmed image will display in
the lower right.
● If you move the zoom lever to the left or
right, you can change the frame size.
● If you press the opqr buttons, you can
move the frame.
● If you press the l button, you can
change the vertical/horizontal orientation
of the frame.
● In an image with a detected face, a gray
frame will appear around faces located in
the upper left of the frame, and the frame
can be used for trimming. You can switch
between frames by turning the
 dial.
● After pressing the m button, press the
qr buttons or turn the  dial to select
[OK], and press the
m button.
Save as a new image and display.
● Perform Steps 4 and 5 on p. 121 .
[ Trimming
Trimming Area
Trimming Area Display
Recorded pixels
after trimming
• , and images cannot be trimmed.
• Trimming is only possible for images shot at aspect ratio 4:3 (vertical 3:4).
•
The number of recorded pixels in a trimmed image will be smaller than
before trimming.