Sony CPD-200SX - Manual (Page 2)

FEDERAL COMMUNICATIONS COMMISSION (FCC)
Radio Frequency Interference Statement
This equipment has been tested and found to comply with the limits for a Class В digital device, pursuant to part 15 of the FCC
rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. Thii
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruc
tions, may cause harmful interference to radio communication. However, there is no guarantee that interference will not occu:
in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can Ы
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of thi
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
To assure continued FCC emission limit compliance, the user must use only the power supply chord and shielded interfact
cable provided when connecting to a host computer. Also, any unauthorized changes or modifications to this equipment may
void the user’s authority to opierate the equipment.
DEPARTMENT OF INDUSTRY CANADA (1C)
This class B digital apparatus meets all requirements of the Candian Interference-Causing Equipment Regulations.
Cet appareil numérique de la class B respecte toutes les exigences du Règlement sur le materiel brouiller du Canda.
WARNING
To prevent fire or shock hazard, do not expose the unit to rain or moisture.
Dangerously high voltages are present inside the set. Do not open the cabinet.
Refer servicing to qualified personnel only.
Hinweise
• Aus ergonomischen Gründen word empfohlen, die Grundfarbe Blau nicht auf dunklem Undergrund zu verwenden
(schlechte Erkenbarkeit, Augenbelastung bei zu geringem Zeichenkontrast).
• Aus ergonomixhen Gründen (flimmern) sollen nur Darstellungen bei Vertikalfrequenzen ab 70 Hz (ohne Zeilensprung) vei
Wender weden.
Dieses Gerät entspricht den folgenden Europäischen EMV-Vorschriften für den Betrieb in Wohngebieten, gewerblichen Ge
bieten und Leichtindustriegebieten.
EN55022/1994 Klasse B
EN50082-1 /1992
EN60555-2/1987
Die in diesem Gerät erzeugten Röntgenstrahlen sind durch die eigensichere Kathodenstrahlröhre aus­
reichend abgeschirmt, UnsachgemäBer Betrieb, insbesondere das Verändern der Hochspannung oder
der Einbau eines anderen Bildröhrentyps können zur erhöhten Emission von Röntgenstrahlen führen. Ein
so veränderter Monitor entspricht nicht mehr der Zulassung und darf daher nicht mehr betrieben w/erden.
Maximale Beschleunigungsspannung 27 kV.