Setting the clock – Sony GV-300 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Setting the Clock
Before you set the clock, install a lithium battery. With a lithium battery installed, this unit powers
the clock and keeps the last channel in memory when the power source is disconnected.
To remove the lithium battery
Press the battery upward and remove it as illustrated.
18
Approximately 1 year in normal operation.
If the lithium battery becomes weak, the AM 12; 00 indication appears on the screen when the
DATA SCREEN button is pressed. In this case, replace the battery with a Sony CR2032 lithium
battery. Use of a battery other than a Sony CR2032 may present a risk of fire or explosion.
After replacing the battery, reset the clock.
Notes on lithium battery
• Keep the lithium battery out of the reach of children.
Should the battery be swallowed, consult a doctor immediately.
• Before use, wipe the battery with a dry cloth to assure a good contact.
• Be sure to observe the correct polarity when installing the battery.
• Do not hold the battery with metallic tweezers, otherwise a short-circuit may occur.
• Do not break up the battery or throw it into a fire because it may explode. Carefully dispose
of the used batteries.
Warning
Battery may explode if mistreated. Do not recharge, disassemble or dispose of in fire.
19