Playing back the recorded tapes – Sony GV-300 User Manual
Page 23
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Using the Timer-Activated Feature
1b atop the timer reMrdlng
Press the TIMER REC ON/OFF button again.
The TIMER REC lamp goes out.
fb check the setting
Press the TIMER SET/CHECK button while the TIMER REC lamp is lit.
The power is turned on and the starting and ending time is displayed for a few seconds.
- MB tIMER REC
IMEH SEV—/
1b change the timer setting after completing №e setting
Press the TIMER REC ON/OFF button to cancel the timer recording mode, then turn the unit on
and set the timer again.
1b sat the timer while the tape is running
Only the starting and ending time can be set during playback or recording. After stopping the
tape, set the recording mode (SP/LP) and channel, and then press the TIMER REC ON/OFF
button.
If a power interruption occurs when the unit la connected to the AC power source
Recording stops. Recording starts again after the power is resupplied. When a power interrup
tion occurs during the timer recording standby mode and the power is resupplied, the timer set
tings will not be affected as long as the lithium battery is installed.
1b rsMTd to tha and of the tape
Set the starting and ending time the same. When the tape reaches the end. recording will stop
and the power goes oft.
44
Playing Back the Recorded Tapes
45