Sony CDP-670 - Manual (Page 4)

Installing the CD Player
Notes on Installation
Place the unit in a location with adequate air circulation to
prevent internal heat build up in the unit.
Do not place the unit on a soft surface, such as a rug that
would block the ventilation holes on the bottom.
Do not install the unit:
— near heat sources such as radiators or air ducts.
— in a place subject to direct sunlight, excessive dust,
mechanical vibration or shock.
On moisture condensation
If the player is brought directly from a cold to a warm
location, or is placed in a very damp room, moisture may
condense on the lens inside the unit. Should this occur,
the player will not operate. In this case, remove the disc
and leave the player turned on for about an hour until the
moisture evaporates.
Notes on the Remote Commander and Remote
Control Operation
Keep the commander away from extremely hot or humid
places.
Avoid dropping any foreign objects into the commander
casing, particularly when replacing the batteries.
Avoid exposing the remote sensor to direct sunlight or
lighting apparatus. Such exposure can cause a
malfunction.
To avoid damage caused by battery leakage and corrosion,
remove the batteries when the commander will not be used
for a long time.
Installing Batteries in the Remote Commander
On battery life
• About half a year of normal operation can be expected
when using the Sony SUM-3 (NS) batteries.
• When the batteries are run down, the remote commander
will not operate the unit. In this case, replace both batteries
with new ones.
4