Appendix: other information 89 – Sony SAT-A3 User Manual
Page 89
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Symptom
Possible Causes and Remedies
Remote control does not work
□
To operate your TV or other video components, make sure you've programmed
the remote properly. See "Programming the Remote Control" on page 85. Note:
The remote codes may be erased whenever you remove the batteries. Program
the remote again if you've removed or replaced t^e batteries.
□
Press the appropriate FUNCTION button (DSS, TV, VTR(VCR)) for the
component you want to operate. These buttons flash to indicate which
component the remote control is set to operate.
Check to make sure the batteries are inserted correctly, and that the batteries are
not dead. See page 6.
SAT-A3 Only:
If you are having problems with the RF function, check that the RF
antenna is connected properly and that you are using the remote control within
operating range of the DSS receiver (see "Setting Up the RF Antenna (SAT-A3
Only)" on page 19). Make sure that RF transmission is enabled (see "Selecting
IR/RF Transmission (SAT-A3 Only)" on page 71). Make sure the DSS receiver
and remote control are using the same security code (see"Setting the Security
Code (SAT-A3 Only)" on page 72).
Q Try removing the batteries and reinserting them without touching any buttons
on the remote control.
□
□
If you are unable to resolve problems with your system, please see
"Customer Support" on page 2 for customer support information and
telephone numbers.
Appendix: Other Information 89