Sony CCD-FX620 - Manual (Page 25)

Identifying the Parts
WIrelM» Remot* Commander
361 Viewrtinder (p. IS)
You can monitor the monochrome picture being
recorded or played back. For details on the
indicators m the viewfinder, see page 54.
№ Camera racording/battary lamp (p. 17)
This red lamp lights up while camera recordihg.
when It flashes, the battery is almost empty or the
tape IS near its end.
3 COUNTER RESET button (p. 17, 3S)
Press to reset the tape counter to zero.
3 ZERO MEM bvrtton {p. 3$, 36)
Press to memorize the zero point of the tape
counter. This will stop the tape at the counter's
zero point. Press it while Ihe tape transport is
stopped or paused.
3 TAPE/BATT CHECK button {p. 18)
Press to display the tape remaining indicator or
battery capacity remaining indicator m Ihe
viewfinder.
Viewfinder adjustment ring (p. IS)
To focus the viewfinder lens, turn this ring until
the indicator in the viewfinder comes into sharp
focus. To adjust the sports tinder, turn the ring
clockwise completely.
3 Eyecup
VVhen looking in the viewfinder with glasses,
bend back the eyecup.
S BEEPswftcb (p. IS)
5ei 10 ON 10 beep when starting ana stopping
camera recording or when unusual conditions
occur. To deactivate the beep, set it to OFF
¡3 ■ REMOTE COMMANDER switch (p. 26)
Set to ON to use the Remote Commander
(supplied). When you connect a wired remote
control unit to the camcorder, set it OFF.
3 Battery mounting surface
to remotely control the camcorder Activate the
camcorder before you use the Bemoto
Commander.
T Tape transport buttons (p. 2S]
¡h DATA SCREEN button
Press to display the viewfinder screen indicators
on a TV when you connect the camcorder to a TV.
To erase the indicators, press it again.
Attaching tha
ShouWar
Strap
Attach the supplied shoulder strap to the hooks.
buttons from being accidentally pressed. Before
using this Remote Commander, slide m the
opposite direction of the arrow
Ï START/STOP button (p. 17)
[6] Power zoom button <p. 19)
48 49