Sony CCD-FX620 - Manual (Page 6)

Installing the Lithium Battery
A lithium batiery has positive and negative poiarities.
Positive side of Ihe battery is marked * Negative side has no polarity sign.
Setting the Date and Time
Installing the Lithhim Batteiy
To activate the clock and store birth dates in the camcorder's memory, you must first install a lithium battery.
(1)
Remove the lithium battery holder located below ihe gnp strap ot the camcorder ¡2} Inslall the supplied
CR2025 lithium battery with the » side lacmg down. (3)Pul the lithium battery holder into the camcorder.
Lithium Battery Life
The battery will last for approximately t year under normal conditions. When the lithium battery becomes
weak, the £> indicator will flash in the viewfinder tor about 5 seconds when you turn STANDBY up while the
POWER switch IS set to CAMERA. In this case, reptene the battery with a Sony CR2025 or Ouraceil
DL-202S. Use of any other battery may prasant a risk of fira or axpiosion.
Before setting the dock, make sure a power source and lithium battery are installed. (1) While pressing the
small green button on the POWER switch, slide the POWER switch to CAMERA. (2) Turn STANDBY up.
(3) Press DATE |*) and TIME (NEXT) simultaneously for a few seconds until the year indicator flashes m the
display window. (4) Adjust the flashing digits for the year, month, day. hour, and mmule by using DATE (*)
and TIME(NEXT) The clock starts from '00" second after you press TIME (NEXT) following the adjustment of
the minutes. If you press TIME (NEXT) again, the time indicator will disappear.
When replacing the lithium battery, keep the battery pack or other power source attached. Otherwise. Input
data will be cleared and you have to store the data agam.
Warning
Battery may explode it mistreated. Do not recharge, disassemble or dispose of m fire.
Caution
Keep the lithium battery out ot the reach ot children. Should the battery be swallowed, consult a doctor
immediately.
10
To check the preset date and time
Press DATE (+) to display the date indicator m the display window and in the viewfinder. Press TIME (NEXT)
to display the lime indicator. When you press the same button again, the indicator goes out, and. in the
display window, the tape counter appears.
The year irtdlcator changes as follows:
93 (1993)--------* 99 {1999) - 00 (2000)-------- *20 (2020)
Note on the time iiHlIcator
The internal clock of this camcorder operates on a 12-hour cycle.
12;00 AM stands for midnight 12:00 PM stands tor noon.
H