Sony STR-AV1070X - Manual (Page 23)

Audio Recording
Recording on an Audio Tape Deck or DAT Deck Tape Dubbing
POWER — ON
LÌ3
Og i
TZZn“
to DAT or
TAPE 1. 2 OUT ir
Record player
2 DAT or Tape deck CD player 3
VCR
1 Select the desired program source with the
FUNCTION selector.
For an FM/AM broadcast, tune in the desired station
2 Set the tape (DAT) deck in the recording mode.
3 Start the selected program source.
1 Insert the recorded tape into tape deck 1 (or the
DAT deck).
2 Insert a blank tape into tape deck 2 and adjust the
recording level.
3 Press TAPE 1 or DAT to select the deck for
playback.
4 Start the playback of the tape (or the DAT) in tape
deck 1 (or the DAT deck), and set tape deck 2 in the
recording mode.
Dubbing will start.
Notes on recording
•
Use ADAPTOR OUT for the recording with the
equalizer and SURROUND effects.
• For other REC OUT jacks, the settings of the VOLUME,
SURROUND, BALANCE, and graphic equalizer do not
have any effect on recording.
Monitoring the recorded sound
If you have connected a tape deck having separate record
and playback heads to the TAPE 2 jacks, you can monitor
the recording results. While recording or dubbing, press
the TAPE 2 MONITOR button. To listen to the source sound
again, press the button again.
Note on tape dubbing
Tape dubbing is possible only in the following directions:
From
(playback side)
To
(Recording side)
FUNCTION
selector to be
pressed
Tape deck
connected to
TAPE 1 IN Tape deck connected
to TAPE 2 OUT
TAPE 1
DAT deck connected
to DAT OUT
DAT deck
connected to
DAT IN
Tape deck connected
to TAPE 1 or 2 OUT DAT
23