Sony DCR-TR7000 - Manual (Page 51)

Inserting a scene from a VCR
(1) Set the POWER switch to VTR.
(2) On the VCR, locate just before the insert start point [a], then press 11 to set the VCR
to the playback pause mode.
(3) On'your camcorder, locate the insert end point [c] by pressing or Then
press II to set it to the playback pause mode.
(4) Press ZERO SET MEMORY on the Remote Commander. The ZERO SET MEMORY
indicator flashes and the end point of the insert is stored in memory.
(5) On your camcorder, locate the insert start point [b] by pressing then press two
# IŒC buttons at same time to set your camcorder to Ù\e recording pause mode.
(6) First press 11 on the VCR, and after a few seconds press 11 on your camcorder to
start inserting the new s<^ne.
Inserting automatically stops near the zero point on the tape counter. Your
camcorder automatically returns to the recording pause mode.
4
0:00:00
ZERO SET
MEMORY y^EROsÉV'
y- MEMORY,
/'billin''
1
B
•
To change the insert end point
Press ZERO SET MEMORY again after step 5 to erase the ZERO SET MEMORY
indicator and begin from step 3.
* •
Notes
• The zero set memory function works only for tapes recorded in the DigitalS H system.
•The picture <md sound recorded on the section between the insert start and end points
will be erased when you insert the new scene.
When the inserted picture is played back
The picture may be distorted at the end of the inserted section. This is not a
malfunction.
To insert a scene without setting the insert end point
Skip step 3 and 4. Press ■ when you want to stop inserting.
51