Remote control direction, In the viewfinder and on the lcd screen, Notes on the remote commander – Sony CCD-TRV30 User Manual
Page 28: To watch the demonstration, To enter demo mode, To exit demo mode, T] program ae mode indicator (p.26), 2] steady shot indicator (ccd-trv40 only) (p.30), 3] back light indicator (p.25), 4] picture effect indicator (p.28)
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Identifying the Parts
Remote Control Direction
Aim the Remote Commander to the remote sensor within the range as shown below.
In the Viewfinder and On the LCD Screen
Notes on the Remote Commander
• Keep the remote sensor away from strong light sources, such as direct sunlight or illumination.
Otherwise, the remote control may not be effective.
• Be sure that there is no obstacle between the remote sensor and the Remote Commander.
• This camcorder works at commander mode VTR 2. The commander mode (1, 2, and 3) are used to
distinguish this camcorder from other Sony VCRs to avoid remote control misoperation. If you use
another Sony VCR at commander mode VTR 2, we recommend you change the commander mode or
cover the remote sensor of the VCR with black paper.
To Watch the Demonstration
You can watch a brief demonstration of pictures with special effects.
If the demonstration appears when you turn on the camcorder for the first time, exit the demo mode to
use your camcorder.
To enter Demo mode
(1) Remove the cassette and turn the POWER switch to OFF.
(2)
Turn STANBY up.
(3)
While holding down O, turn the POWER switch to CAMERA. Demonstration starts.
If a cassette is inserted, the demo mode will be cancelled. Note that once you enter demo mode, this
mode is retained as long as lithium battery is in place. Therefore demonstration starts automatically 10
minutes later every time you turn the POWER switch to CAMERA or 10 minutes after the cassette has
been removed.
To exit Demo mode
(1)
Turn the POWER switch to OFF.
(2)
Turn STANBY up.
(3)
While holding down □, turn the POWER switch to CAMERA.
[T]
PROGRAM AE mode indicator (p.26)
[2] Steady Shot indicator (CCD-TRV40 only)
(p.30)
[3] Back light indicator (p.25)
[4] Picture effect indicator (p.28)
H] Power zoom indicator (p.12)
U] FADER indicator (p.27)
[7] Warning indicator (p.58)
[8] LP indicator
Lights up when playing back a tape recorded
in LP mode.
[U Tape transport mode (p.10,18)
HOl Tape counter (p.11)
^Remaining tape indicator (p.11)
51 ■» IQ-Ql
<»10-01
5min
1 min
I ) /,,
■ Omin -
' / I 1 1 '
] Remaining battery indicator (p.39)
-i^-»
c
5 AUTO DATE indicator (p.11)
] Date or Time (p.24)
il Recording lamp/Battery lamp (in the
viewfinder)