Checking the recorded picture, Cautions on the viewfinder and the lcd, To stop playback – Sony CCD-TRV30 User Manual
Page 9: To begin re-recording, Hints for better shooting
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Hints for Better Shooting
Checking the Recorded Picture
Place the camcorder on a flat surface or use a tripod
Try placing the camcorder on a table top or any other flat surface of suitable height. If you have a
tripod for a still camera, you can also use it with the camcorder. If the camcorder is difficult to balance
on a tripod, use the supplied adaptor.
You can attach a tripod to the adaptor,
[c]
Do not leave the tripod adaptor on the camcorder if the camcorder is not mounted on a tripod. When
attaching a non-Sony tripod, make sure that the length of the tripod screw is less than 9/32 in. (6.5
mm). Otherwise, the screw may damage the inner parts of the camcorder.
You can use the stand on the bottom to place the camcorder on a table when recording in a low
position
[d].
[c]
[d]
Cautions on the viewfinder and the LCD
• Do not pick up the camcorder by the viewfinder or by the LCD panel,
[e]
• Do not place the camcorder so as to point the viewfinder or the LCD screen toward the sun. The
inside of the viewfinder or the LCD panel may be deformed. Be careful when placing the camcorder
under sunlight or by the window,
[f]
[e]
[f]
The EDITSEARCH function is used to view the recorded picture for a moment during recording.
Using EDITSEARCH, you can review the last recorded scene or check the recorded picture on the
LCD
screen. You can also review the picture in the viewfinder.
(1) While pressing the small green button on the POWER switch, turn it to CAMERA,
(2) Turn STANDBY up.
(3) Press the - (@) side of EDITSEARCH momentarily; the last few seconds of the recorded portion
plays back. You can also monitor the sound.
(Rec Review)
Hold down the - side of EDITSEARCH until the camcorder goes back to the .scene you want. The
last recorded portion is played back. To go forward, hold down the + side.
(EditSearch)
To Stop Playback
Release EDITSEARCH.
To Begin Re-recording
Press START/STOP. Re-recording begins from the point you released EDITSEARCH, Provided you do
not eject the cassette, the transition between the last scene you recorded and the next scene you record
will be smooth.