Installing the battery pack, Removing the battery pack, To eject the cassette – Sony CCD-TRV30 User Manual
Page 5: To prevent accidental erasure, Inserting a cassette, Charging and installing the battery pack
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Charging and Installing the Battery Pack
Installing the Battery Pack
1) Lift up the viewfinder.
2) Align the right side of the battery pack with white line on the camcorder, and slide the battery pack
to the right.
Removing the Battery Pack
1) Lift up the viewfinder.
2) While pressing ВАТТ, slide the battery pack to the left.
Inserting a Cassette
Make sure that a power source is installed.
(
1
)
While sliding the lid release knob, lift up the lid. Then open it.
(
2
)
Press EJECT. The cassette compartment automatically lifts up and opens.
(3) Insert a cassette (not supplied) with the window facing out.
(4) Press the PUSH mark on the cassette compartment to clo.se it. The cassette compartment
automatically goes down.
(5) Close the lid until it locks.
To Eject the Cassette
While sliding the lid release knob in the direction of the arrow, lift up the lid of the cassette holder and
press EJECT.
To Prevent Accidental Erasure
To prevent accidental erasure, slide the tab on the cassette to expose the red mark. If you try to record
with the red mark exposed, the and ^ indicators flash in the viewfinder, and you cannot record.
To re-record on this tape, slide the tab back out covering the red mark.