Sony CDP-C435 - Manual (Page 18)

Playing in a Specified Order
Recording Prorammed Selections
You can make a program to be recorded fit to your tape
length. By entering
II, you can divide a program into side A
and B. At the end of a program for side A, the player
automatically pauses before side A ends so that a selection
is not cut off.
DISC 1-5
42
M
□ rn-rJ
1 1.
( I'I'I'I ICP_H"flf° °T~*~
TWE 0£AR CHECK
1
Program the selections to be recorded on side
A of your tape by repeating steps 1 to 3 on
pages 16 and 17.
Press II to program selections for side B.
The selections to be recorded on side A will be
programmed.
Program the selections for side B.
Repeat steps 1 to 3 on pages 16 and 17.
Start recording on the cassette deck,
then press >■.
■(5
Program play starts.
To play the selections for side B
Play automatically pauses at the point a pause is
programmed. Set the tape to the beginning of side B, then
press
P or II. The selections for side B will start playing.
Note
By pressing
II. a pause is programmed as a selection. The player counts
pauses as selections to be programmed.
To check the remaining time
Press TIME once to see the remaining time on the current selection, twice to
return to the initial display. The total remaining time does not appear during
program play.
Checking Your Program
Press CHECK. The first selection in the program appears.
Each time you press CHECK, the next selection in the
program appears. One of the tape indicators or ‘[¿«j*
appears when the program for side A or B is being played or
checked.
Changing Your Program
To delete the last selection
Press CLEAR during stop. Each time you press CLEAR, the
last selection in the program will be deleted.
To delete a selection
Press CHECK repeatedly until the selection you want to
delete is displayed. Then press CLEAR.
To add selections to the end of the program
Press DISC 1-5 to select the disc and press the numeric
buttons for those selections. You can do this during stop,
play or pause.
To change the order
Hold down CLEAR to erase the program. Then repeat the
programming procedure from the beginning.
To make a program by referring to disc labels
You can meike a program while the disc tray is open. Follow
the steps 2 to 3 on page 16, then 4 on page 17. Program
Edit is not available.
1fi