Fcc regulations and information, Service requirements, Declaration of conformity – Sony SAT-A50 User Manual

Page 74: Radio interference information

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

FCC Regulations and Information

Your Digital Satellite Recei\ er has been registered by the Federal

Communication Commission (FCC) as not being harmful to the

telephone network when connected directly to the telephone
lines. In order to fully comply with the Rules of the FCC, the
following instructions should he read carefully and followed
completely where applicable;

1 The Federal Communication Commission (FCC) has

established Rules which permit this device to be directly

cormected to the telephone netw'ork. Standardized jacks are

used for these connections. This equipment should not be
used on party lines or coin phones.

2 If fhis device is malfunctioning, it may also be erasing harm

to the telephone network; this device should be

disconnected until the source of the problem can be

determined and until repair has been made. If this is not
done, the telephone company may temporarily disconnect
serv'ice.

3 The telephone company may make changes in its technical

operations and procedures; if such changes affect the
compatibility or use of this device, the telephone company is

required to give adequate notice of the changes. You will be
advised of your right to file a complaint with the FCC.

4 If the telephone company requests information on what

equipment is connected to their lines, inform them of:

a. The telephone number to which this unit is connected.

b. The ringer equivalence number.

c. The USOC jack required.

d. The FCC Registration Number.

5 Items (b) and (d) are indicated on the label. The Ringer

Equivalence Number (REN) is used to determine how many
devices can be connected to your telephone line. In most
areas, the sum of the RENs of all devices on any one line
should not exceed five (5). If too many devices are attached,
they may not ring properly.

Service Requirements

In the event of equipment malfunction, all repairs should be

performed by our Company or an authorized agent. It is the

responsibility of users requiring service to report the need for

service to our company or to one of our authorized agents. For

service, call 1-800-838-7669.

Declaration of Conformity

Trade Name:

Sony

Model No.:

SAT-A50/SAT-B50

Responsible Party: Sony Electronics Inc.

Address:

1 Sony Drive, Park Ridge, NJ. 07656 USA

Telephone No.:

201-930-6973

This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions: (1) This

device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.

Radio Interference Information

This equipment has been tested and found to comply with the

limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that

interference will not occur in a particular installation. If this

equipment does cause interference to radio or television
reception (which you can determine by turning the equipment off
and on), you are encouraged to try to correct the interference by
one or more of the following measures:

• Reorient or relocate the receiving antenna (the antenna for

radio or television that is receiving the interference)

• Change the position of the Digital Satellite Receiv^er with

respect to the radio or television equipment that is receiving
the interference

• Move the Digital Satellite Receiver away from the

equipment that is receiving the interference

• Plug the Digital Satellite Receiver into a different outlet so

that the Digital Satellite Receiver and the equipment
receiving the interference are on different branch circuits

Shielded cables and I/O cords must be used for this equipment

to comply with the relevant FCC regulations. Changes or

modifications not expressly approved in writing by Sony

Electrorrics, Inc., void the user's authority to operate this

equipment.

If these measures do not eliminate the interference, you should
consult your Digital Satellite Receiver dealer or an experienced
radio/television technician for additional suggestions. In

addition, you may find the following booklet prepared by the

Federal Communications Commission helpful: "How to Identify

and Resolve Radio-TV Interference Problems." This booklet is
available from the U.S. Government Printing Office, Washington,

D.C., 20402 Stock No. 004-000-00345-4.

74

Advertising
This manual is related to the following products: