Sony SAT-A50 - Manual (Page 9)

step 3: Connecting Your TV
Connect your TV to the Digital Satellite Receiver as shown below. Refer
to your TV's instruction manual for more information.
O if you have a local TV antenna or cable
company service
Connect it to the VHF/UHF BSJ jack on
your Digital Satellite Receiver using a
coaxial cable or RF adapter (not supplied).
You can view local stations using your TV
controls.
C/3
cu
n
id
fi
o
ft
<
n
Note
You must use the VHF(SAT)/UHF OUT jack
to connect to your TV or VCR when a local
TV antenna or cable company service is
connected to the VHF/UHF IN jack (see "2c"
below and on page 10).
@ If your TV has A/V input
jacks
Connect the VIDEO OUT
jacks on your Digital Satellite
Receiver to the A/V input
jacks on your TV using the
supplied A/V cable. (Be sure
to match the colors on the
jacks with the colored plugs
on the A/V cable.)
^ If your TV has an S-Video
input
Use the S-Video cable instead
of the yellow video
connection.
If your TV has only one audio
input, connect it to the
L(mono) jack on the receiver.
A/V Cable
VIDEO
(yellow)
OR
S-Video
S-Video
Cable
N nnmrj~p
1
S VIDEO
VIDEO
L(MONO)
-AUDIO- •
fi
0
^ If your TV does not have
A/V jacks
Connect the VHF(SAT)/
Coaxial UHF OUT jack to the VHF/
Cable UHF input jack on your TV
using coaxial cable.
Set the CH3/CH4 switch to
the channel that does not
carry off-air broadcasts in
your area.
Note
With this connection, your
input source is channel 3 or
channel 4 depending on how
you set the CH3/CH4 switch
on the receiver.