Specifications, General, Optional accessories – Sony MDS-JE510 User Manual
Page 34: Inputs, Additional information
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Additional Information
Specifications
System
Disc
Laser
Laser output
Laser diode properties
Revolutions (CLV)
Error correction
Sampling frequency
Coding
Modulation system
Number of channels
Frequency response
Signal-to-noise ratio
Wow and flutter
MiniDisc digital audio svstcm
MiniDisc
Semiconductor User (A. = 780 nm)
Emission duration: continuous
Less than 44.8 pW*
* This output is the value measured at a
distance ot 2tX' mm from the ohjectivc
lens surface on the Optical l*ick-up
BliK'k with 7 n>m aperture.
Material: CaAlAs
400 rpm to ‘iOO rpiii
Advanced Cross Interleave Rtvd
Stilomon Code (ACIRC)
44.1 kHz
Adapti\’e Transform Acoustic Ccxiing
(ATRAO
EFM (Eight-to-Fourteen Modulation)
2 stereo channels
5 to 20,000 Hz ±0.3 dB
Over % dB during playback
Below measurable limit
General
Power requirements
120 \' AC. W) Hz
Power consumption
1^ W
Dimensions (approx.) (w/h/d) incl. projecting parts
430 X 93 X 280.5 mm
(17x3 7^x 11 7, in.)
Mass (approx.)
3.5 kg (7 lbs 11 oz)
Supplied accessories
See page
4.
Optional accessories
RcxTordable MDs: MDW-6t) (60 min), MDW-74 (74 min)
Optical cable: POC-L'^A
U.S. and foreign patents licen.sed from Dolby Laboratories
Licensing Cor^x>ration.
Design and spc'cifications are subject U> change without
notice.
Inputs
Jack type
Input
impedance
Rated Minimum
input input
LINE
(ANALOG) IN
Phono jacks 47 kilohms 500 mVrms 125 mVrms
DIGITAL IN
Square
optical
connector
jack
Optical
wave
length:
660 nm
-
Outputs
Jack type
Rated output
Load impedance
PHONES
Stereo
phone
jack
10 mW
32 ohms
LINE
(ANALOG)
OUT
Phono -
jacks
2 Vrms
(at 50 kilohms)
Over 10 kilohms
DIGITAL
OUT
Square .
optical
cxHutecteM*
jack
-18 dBm
Wave length;
660 nm
32