Sony RM-V15 User Manual
Page 25
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Troubleshooting
If you're having problems setting
up or using the Remote
Commander:
■ When setting up the Commander,
carefully go through the procedures
described under "Setting Up the
Commander" on page 8. If the code
that's listed first for your component
doesn't work, try all the codes listed
for your component — in the order
in which they're listed. If all the
codes fail to work (or if your
component is not listed in this
manual), try using the procedures
under "Searching for the Correct
Code" on page 14.
■ When setting up the component, if
you press the wrong button, move
the slide switch to a different
position. Then reset the slide switch
and start the procedures over again.
■ Check that you're aiming the
Commander directly at the
component, and that there are no
obstructions between the
Commander and the component.
■ Make sure the batteries you're using
are not worn out, and that they're
inserted correctly. Note that
whenever you remove the batteries
— to replace them, for example —
the preset codes are erased from
memory and must be reset.
25