Adjustments using the set up button, 1 press set up, Adjusting the control a1 n auto function – Sony STR-DE935 User Manual
Page 48: 3 turn the jog dial to select “on" or "off, 3 turn the jog dial to select "on" or "off, Selling |he^.t<^vidm
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Adjustments Using the SET UP Button
The SET UP button allows you to make the following
adjustments.
Selling |he^.t<^vidM
........ .
This parameter lets you specify the video input to be used
with the audio signals from the 5.1CH INPUT jack.
The 5.1CH video input is set to DVD/LD by default.
1
Press SET UP.
2
Press the cursor buttons « or »to select
"5.1CH V:".
3
Turn the jog dial to select the video input you
desire.
Setting up the 2 way^remote- ««
0
«ifeicf»si'
<W>»35only)
This receiver is shipped from the factory with the 2 way
remote control system set to "ON." Normally, you can use
the receiver as is.
However, if you want to use this receiver together with
another component that is also compatible with the 2 way
remote control system, be sure to perform the following
operation to limit response to signals sent from the remote
controls.
To use with the TA-E9000ES
Perform the following steps to turn OFF this unit's 2 way
remote control system. Also, be sure the TA-E9000ES is
turned on when using this unit.
O
■o
«
Adjusting the Control A1 n auto function
Turning on the Control A1 II auto function parameter lets
you turn Sony components connected via Control A1
cords (see page 13) on automatically when you press the
corresponding function button.
Auto function is set to ON by default.
1
Press SET UP.
2
Press the cursor buttons (<[ or ]»to select 'AUTO
FUNCTION."
3
Turn the jog dial to select “ON" or "OFF."
To
use
with
other components that have
the
logo
Turn OFF the other component's 2 way remote control
system. For details, refer to the operating instructions
suppled with your other components.
To use with Sony CD piayers CDP-CX260 or CDP-
CX88ES
Turn OFF the remote control adapter switch on the
CDP-CX260 or CDP-CX88ES. For details, refer to the
operating instructions suppled with the CDP-CX260 or
CDP-CX88ES.
Also when using several 2 way remote control system
components together, be sure to place them close together
in order to enable proper remote operation.
1
Press SET UP.
2
Press the cursor buttons (< or »to select
"2
WAY
REMOTE."
3
T urn
the jog dial to
se le ct
"ON" or "OFF."
50