Sony SPP-SS951 - Manual (Page 10)

Act^itional tasks
To
Adjust the hiindst't
\oIume
Switch to toue dialing
temporarily
Switch to another call
("call waiting" service*)
Do this
During phone conversations, press (T poma /OO. Each press of
(T pgma /OL ) switches the speaker \ olume bv four le\ els.
Press (*TONE) after you're connected.
The line will remain in tone dialing until disconnected.
Press (FLASH).
Press the button again to get back to the first caller.
* Contact your telephone company to subscribe to this service.
Jr-
Note
If fhe handset beeps every second during conversation, move closer to the base unit;
otherwise, the call will be disconnected after one minute.
Tip
You can save battery power by setting the RING ON/
ВАТТ SAVE switch on the bottom to ВАТТ SAVE.
The handset won't ring, but you can still make calls.
You can also receive calls if another telephone
connected to the same line rings to inform you on
incoming calls. However, you can't page the handset
from the base unit.
If the battery becomes weak during a call
The handset will beep every three seconds with the TALK/BATT LOW lamp
flashing at the same time. Finish your call and charge the battery pack.
For optimum performance, charge the battery for a full 12 hours.
Note that during the first 10-15 minutes of charging, the phone will be inactive,
i.e., unable to make or receive a call.
After this initial 10-15 minutes, you may be able to use the phone, but the
battery duration will be very short; thus it is recommended that you fully
charge the battery before next use.
Redialing
1
Press (TALK), and wait until the TALK/BATT LOW lamp lights up.
2
Press ( REDIAL/PAUSE ) to redial the number last dialed.
Note
If the number exceeds 32 digits, five short error beeps will alert you that the number can't
be dialed.
To erase the last phone number dialed
Press (REDIAL/PAUSE) twice.
The number will be erased from the memory, and you'll hear a long confirmation
beep.