Sony KP-61S65 - Manual (Page 36)

MDP manufacturer code numbers
Manufacturer Code number
Sony 701
Kenwood 707
Magnavox 703
Maranz 702
Mitsubishi 7Ш
Panasonic 704
Philips 703
Pioneer 702
RCA 702
Sanyo 706
Sharp 705
Yamaha 703
Operating video equipment
Notes
• If more than one code number is listed, try entering them one
by one, until you come to the correct code for your equipment.
• In some rare cases, you may not be able to operate your non-
Sony video equipment with the supplied remote control. This
is because your equipment may use a code that is not included
with this remote control. In this case, please use the
equipment's own remote control unit.
• The code numbers for Sony equipment are assigned at the
factory as follows:
301 (preset code for the supplied
remote control)
302
303
Whenever you remove the batteries — to replace them, for
example — if too much time is taken, the code number may
rev'ert to the factory setting and must be reset.
VHS VCR
8 mm VCR
Beta, ED Beta VCRs
VTR (FUNCTION)
Video operating
buttons
VTR (POWER)
0-9 buttons
ENTER
CH +/-
Use the video operating buttons on the remote
control to operate the video equipment.
Press VTR (FUNCTION) before operating the
video equipment.
Operating a VCR Buttons on the remote control
To turn on or off Press VTR (POWER).
To select a channel
directly Press the 0-9 buttons.
To change channels Press CH +/-.
To record Press ►- while pressing #. First release
►, then release #.
To play Press
To stop Press ■.
To fast forward Press
To rewind the tape Press
To pause Press II.
To resume normal playback, press again.
To search the picture
forward or backward Press ►► or ◄◄ during playback.
To resume normal playback, release the
button.
To change input mode Press TV/VTR.
Operating an MDP Buttons on the remote control
To turn on or off Press VTR (POWER).
To play Press
To stop Press ■.
To pause Press II.
To resume normal playback, press again.
To search the picture
forward or backward Keep pressing ►► or during
playback.
To resume normal playback, release the
button.
To search the chapter
forward and backward Press CH +/-.
Note
• If the video equipment does not have a certain function, the
corresponding button on this remote control will not operate.
3 6 E N Operations