Compaq Deskpro 2000 - Manual (Page 153)

Compaq Deskpro 2000 Series of Personal Computers 6-11
6.10 Riser Board
To remove the riser board, complete the following steps:
1. Remove the access panel (Section 6.6.1).
2. Remove the riser brace (Section 6.7).
3. Remove the expansion boards (Section 6.8).
4. Remove the screws that secure the riser board to the riser brace.
5. Tilt the riser board slightly away from the riser brace and pull up.
Figure 6-11. Removing the Riser Board
To replace the riser board, reverse the above procedure.