HP 2140 - Manual (Page 44)

Replace the print cartridge
3. Push the cartridge down and remove it.
4. Take out a new cartridge from its packaging and carefully remove the tape covering
the printhead.
Hold the cartridge by the colored top or black areas only. Do not touch the copper
area.
5. To load the cartridge insert the cartridge as shown below. When the cartridge is
pushed to the back of the cartridge carrier, push the top of the cartridge until it
clicks into place.
If the cartridge moves loosely in the carrier, it has not clicked into place. Repeat
this step.
6. Close the cartridge compartment cover and control panel.
7. Press Start.
8. Press 1 for new cartridge, or 2 for the old one.
• When you put in a new cartridge, you must choose l :New
• When you put in a used cartridge, choose 2 : used. This helps you to check the
correct amount of ink you have left.
TIP: If you mix up several used cartridges, it is not possible to check the
correct amount of remaining ink. Once you have put in a new cartridge, use it
until it is completely exhausted.
40 Care and maintenance