Casio CLASSPAD 330 3.04 - Manual (Page 147)

20060301
I LIST Variable Element Operations
You can recall the value of any element of a LIST variable. When the values {1, 2, 3} are
assigned to “lista”, for example, you can recall the second value in the “lista”, when you need
it.
You can also assign a value to any element in a list. When the values {1, 2, 3} are assigned
to “lista”, for example, you can replace the second value with “5” to end up with {1, 5, 3}.
After performing the procedure under “Inputting List Data from the Work Area”, perform the
following operation.
S ClassPad Operation
(1) Recall the value of the second element of LIST variable “lista”.
JGQR?:A;U
2-5-2
List Calculations
(2) Assign “5” to the second element of LIST variable “lista”.
D6JGQR?:A;U
Tip
• You can also perform the above operations on the “ans” variable (page 2-2-2) when it contains
LIST data.
Example: {1, 2, 3, 4} U {1, 2, 3, 4}
#:A;U 2
I Inputting List Data Using the Stat Editor Window
Tapping  displays the Stat Editor window, which you can then use to input list data. List
data input this way is assigned to a LIST variable, so you can access it by specifying the
applicable variable name.
For more information about using the Stat Editor window to create a list, see “7-2 Using Stat
Editor”.