Nikon ML-3 Modulite Remote Control Set User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
I'ou should also replace
catteries If the LED starts
clinking after it lights up.
Notes:
• Power/channel selector switch setting on the
receiver must coincide with the channel
selector setting on the transmitter. Otherwise,
power does not turn on. (The receiver
operates in either CHI or CH2 setting when
the channel selector setting on the transmitter
is at A. TRIG.)
• As both transmitter and receiver are
controlled by microprocessors, sometimes
they may fail to operate even with fresh,
correctly installed batteries. In this case, turn
the power switch OFF for a few seconds, then
ON again.
14
Advertising