Handling precautions, Camera care, Lcd panel – Canon EOS Rebel 2000 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Handling Precautions
Camera Care
(1) This camera is not waterproof and cannot be used in rain or under
water. If the camera gets really wet, promptly consult your nearest
Canon Service Center. If there are any water droplets on the camera,
wipe off with a dry cloth. If the camera has been exposed to salt air,
wipe with a clean, well-wrung, damp cloth.
(2) Do not leave the camera in places prone to excessive heat such as in a
car on a sunny day. Excessive heat can cause the camera to
malfunction.
(3) Use only a blower brush to remove any dust on the lens or in the film
compartment. Do not use a cleaner containing organic solvent to clean
the camera body or lens. For stubborn dirt, consult your nearest Canon
Service Center.
(4) When you will not be using the camera for an extended period, remove
the batteries. Store the camera in a well-ventilated, cool, dry place.
Release the shutter a few times occasionally to make sure the camera
still works.
(5) Avoid storing the camera in a laboratory, cabinet, etc., where corrosive
chemicals are present.
(6) Before using the camera after an extended period of disuse, check that
all the camera controls function properly or take it to the nearest Canon
Service Center for inspection. Do this especially before shooting an
important event or going on a trip.
LCD Panel
In time, the camera’s LCD panel display may fade and become difficult to
read. If this happens, have it replaced (at cost) by a Canon Service Center.
At low temperatures, the LCD panel’s display response may become
slower. And at 60‘C or higher temperatures, the display may blacken. In
either case, the display will return to normal at room temperature.