CatEye CC-AT100 - Manual (Page 12)

E
12
• Secure the wire with the wire securing tape as in Fig. 20. Wind
the wire round the outer cable up to the handlebar. When ad-
justing the length, be careful that the wire will not hinder handle-
bar operation.
• By using the rubber pad, attach the bracket close to the handle-
bar stem (Fig. 21).
2. Auto (Automatic Start/Stop) Function
This function enables the unit to start/stop automatically without operation of the S/S button. In this function, AT sym-
bol appears on the screen (Fig. 23). It starts measuring automatically even when the power-saving function is on.
• In this function, it starts/stops by perceiving revolutions of the wheel, so it stops measuring when the wheel ceases
moving.
• While this function is on, 2 seconds may be elapsed at the moment when the main unit is mounted onto the bracket.
• When using this unit on its own apart from bicycle, switch off this function. Operation of the S/S button is needed.
How to Switch on/off Auto Function
Operate the mode button to display the main mode showing T, D or A. Get the stop state by pressing the Set button;
then
AT symbol appears and the Auto function is on. To switch this function off, press the Set button again and
AT symbol disappears.
AT
Slide
Mounting Main Unit
Slide the main unit onto the bracket from front until it clicks into
position. The contacts will automatically connect. To remove the
unit, pull it off forward while pushing down the lever (Fig. 22).
Test
Mount the main unit. Spin the wheel to check if the display shows
the speed. If not, adjust the relative positions of the magnet and
the sensor again following the instructions.
Rubber Pad
Bracket
Wire
Wire Securing
Tape
Speed Sensor
Bracket
Fig.21
Front
Lever
Fig.22
Fig.23
Fig.20