CatEye CC-AT100 - Manual (Page 5)

E
5
FOR SAFE OPERATIONS (IMPORTANT)
For safe and appropriate use, always observe the following.
Caution:
• Don't pay too much attention to your cyclocomputer functions when riding. Keep your eyes on the road and give due
consideration to safe riding.
• This altimeter is not intended to be a specialized measuring device.
Proper use and care:
• Never disassemble the main unit. It can not be re-assembled.
• The main unit is loaded with sensitive components. A strong impact may result in malfunction. Don't intentionally submerge the
main unit under water. Although the main unit is water-resistant (such as rain), it is not designed to be used underwater.
• Don't leave the main unit exposed to direct sunlight for extended periods of time.
• If the main unit is superheated by direct sunlight, the temperature sensor inside of the main unit will not give the correct tempera-
ture.
• The Cat Eye CC-AT100 is essentially a barometer. It measures the change in barometric pressure whether caused by a change in
altitude or a change in weather.
• The current altitude should be calibrated before each ride.
• Sudden temperature change can cause a temporary incorrect altitude display.
• When using this unit as an independent altimeter, switch off the bicycle symbol to allow it in the continuous measuring mode.
• Static electricity might cause incorrect data.
• If the S/S(Start/Stop) button, Mode button and Set button are pressed simultaneously, all the stored data will be erased.
• In an aircraft, the unit will not give a correct data because of the regulated pressure.
Maintenance:
• When the main unit or the contact gets wet, dry it off with a cloth; rust will cause functional errors.
• Fasten the magnet and the speed sensor securely, and check their relative position periodically. Incorrect attachment of these
parts may cause an accident.
• If the altitude sensor cover is clogged with mud or sand, it will stop measuring accurately. Clean it off according to "Daily Care"
instructions.
• If the main unit or accessories/attachments become dirty with mud etc., gently wash with mild soap and wipe dry with a soft cloth.
Never apply paint thinner, benzine or alcohol; damage will result.