Cobra Electronics MR HH425LI VP - Manual (Page 21)

Introduction
35 Nothing Comes Close to a Cobra ® 34 English
Antenna, Wrist Strap
and Belt Clip
Batteries and Charger
Antenna, Wrist Strap and Belt Clip
•
Antenna Installation
The flexible antenna for the radio is shipped separately in
the package and must be attached before you use the radio.
1. Align the base of the antenna with the socket in the
top of the radio.
2. Screw it all the way into the socket. Be sure that
the seal seats properly.
NOTICE
Operating the radio without the antenna in place may
damage the unit. The radio is not waterproof until the
antenna and battery pack are in place with their seals
properly seated.
Wrist Strap
The radio comes with the wrist strap already attached.
It can be easily removed if you choose not to use it.
Belt Clip
Use the spring-loaded belt clip to carry the radio on your
belt.
1. Press open the belt clip, slide it over the belt and release
the clip.
2. Insert the round guide on the back of the radio into the
guide channel on the back of the belt clip. You must have
the radio upside-down, as shown, to remove it from the
belt clip.
3. Once the knob has been inserted all the way into
the belt clip channel, the radio will swing freely
while being securely retained.
Installation
Batteries and Charger
•
The radio is shipped with a sealed lithium-ion (LiON) battery
pack (P/N CM 110-010) that is rechargeable.
WARNING
The charger provided with this radio is only to be
used to charge the battery pack provided. Do Not
charge any other type of batteries in the charger as
fire, explosion or battery damage will occur.
Avoiding extreme room temperatures will also help
prolong the life of the battery pack for the radio.
When your rechargeable batteries begin to discharge too
quickly, it is time to install a new battery pack. Your radio
will also operate with six (6) high-quality AA alkaline
batteries, using the AA alkaline battery tray (provided with
this radio).
Installing the Battery Pack
1. Position the battery pack to line up the three (3) external
alignment tabs to the alignment slots in the radio.
2. Engage the battery pack into the radio until battery pack
is fully seated against the radio housing.
3. Pivot the locking tab up until it snaps into place on the
back of the battery pack.
VHF Marine Radio Protocols Installation
Install Antenna
Wrist Strap
Belt Clip Secured to Belt
Insert Knob onto Belt Clip
Secure Radio
Lithium-Ion Battery Back
Install Battery Pack