Cobra Electronics MR HH425LI VP - Manual (Page 30)

53 Nothing Comes Close to a Cobra ®
Setup Mode Programming
52 English
Setup Mode Programming
CTCSS and DCS Code Scan Mode
This mode will allow you to scan for all incoming audio
CTCSS and DCS coded signals.
To Set CTCSS Code Scan:
1. Display will show current CTCSS working channel.
CTCSS and SCAN icons and small digit CTCSS Code
number will be flashing. DCS is not active during
CTCSS operation.
2. Press Channel Up/Down button to start CTCSS
Code number scan.
3. If there is no input activity within five (5) seconds,
CTCSS Code scan will automatically continue.
4. When a valid CTCSS Code is detected, the radio will
stop scanning and open a path to the incoming
CTCSS audio transmission. This connection will
continue for as long as the signal is present. When
the audio transmission ends, the CTCSS Code Scan
will resume after five (5) seconds.
5. Press Call/Enter/Setup button to save entry and
move to the next setup programming mode.
To Set DCS Code Scan:
1. Display will show current DCS working channel.
DCS and SCAN icons and small digit DCS Code
number will be flashing. CTCSS is not active during
DCS operation.
2. Press Channel Up/Down button to start DCS Code
number scan.
3. If there is no input activity within five (5) seconds,
the CTCSS Code scan will automatically continue.
4. When a valid DCS Code is detected, the radio will
stop scanning and open a path to the incoming DCS
audio transmission. This connection will continue
for as long as the signal is present. When the audio
transmission ends, the DCS Code Scan will resume
after five (5) seconds.
5. Press Call/Enter/Setup to save entry and move to
the next setup programming mode.
VibrAlert ® Mode, Call Tone Mode, Roger Beep Mode and Key Tone
Mode
The VibrAlert ® , Call Tone, Roger Beep and Key Tone setup procedures are the next
four (4) settings in GMRS Mode Programming. Follow the same procedures on
pages 47 through 49, in Marine (VHF) Setup Programming, to set these functions.
After these four (4) settings have been made, press Call/Enter/Setup button to save
each entry and move to the next setup programming mode.
You have now ended GMRS Setup programming mode and will enter GMRS
Standby mode.
Operating Your Radio Operating Your Radio
CTCSS Code Scan
DCS Code Scan